From the following list of Shut-In procedure while drilling, which step is followed by “Space out drill string”?

What is the purpose of the first circulation of Driller’s method?

Which is the correct statement from the following about float Bumping procedure?

What is NOT the correct statement of driller’s method well control?

What is the most important item from the below list before the kill operation begins?

What are the advantages of the Driller’s method?

What are the disadvantages of the Driller’s method?

What side of pressure should be maintained constant when you need to adjust the flow rate during well control operation?

For the FIRST circulation of driller’s method, which pressure must be maintained constant during well kill operation?

Many items of information need to be gathered when a well kicks. These include the following EXCEPT;

If the slow pump rate is 30 SPM with 400 psi pressure and initial shut inn drill pipe pressure is 300 psi, then what should be approximate initial circulating pressure be?

The initial shut-in drillpipe pressure (SIDP) is 500 psi and the current depth is 9,500’ MD / 8,500 TVD. The current mud weigh is 9.5 ppg.

What is the kill weight mud?

The current mud weight is 9.2 ppg and the kill weight mud required is 10.0 ppg. The overall volume to weight up is 500 bbl.

How much barite do you require to weight up the system?

The current mud weight is 9.2 ppg and the kill weight mud required is 10.0 ppg. The overall volume to weight up is 500 bbl.

How much is the volume increase in the system?

Current mud weigh is 9.5 ppg and the well depth is 9,600’MD/9,000 TVD. The well is shut in and shut in drill pipe pressure is 600 psi.

What is the reservoir pressure at the present depth?

Before start circulating, you have the following information

Original Shut in Drill Pipe Pressure = 500 psi

Initial Circulating Pressure (ICP) = 1500 psi

After end of 1st circulation of Driller’s Method, the drillpipe pressure gauge and the casing pressure gauge shows that the circulating drill pipe pressure = 1500 psi and casing pressure = 650 psi (see the figure below).

How is this operation?

The first part of Pc Max is determined by which formula?

Before start the first circulating, you have the following information

Original Shut in Drill Pipe Pressure = 500 psi

Initial Circulating Pressure (ICP) = 1500 psi

After end of 1st circulation of Driller’s Method, the drillpipe pressure gauge and the casing pressure gauge shows that the circulating drill pipe pressure = 1500 psi and casing pressure = 500 psi (see the figure below).

How is this operation?

Before starting 1st circulation of driller’s method, you have this following information

Original Shut in Drill Pipe Pressure = 500 psi
Shut in casing pressure = 800 psi

After complete the 1st circulation, you shut down pumps and you see the drill pipe pressure and the casing pressure as this figure below

How is this operation?

When you shut the well in, you record these following pressure readings.

Initial Circulating Pressure (ICP) = 1500 psi

Original Shut in Drill Pipe Pressure = 500 psi

After you circulate the 1 st step of driller’s method, you see drill pipe pressure and casing pressure reading like this image below.

How is this operation?

When will the casing pressure reach the maximum value?